⏱ 2 min read

How to prep your nails before a UV gel manicure

Trimming, filing, pushing back cuticles, buffing and dehydrating: the prep that makes gel last for weeks.

How to prep your nails before a UV gel manicure

The essentials in 30 seconds

  • It's often overlooked, but how long a gel lasts is decided before the first coat.
  • Always file in one direction, from the edge towards the center, never back and forth: sawing motions break up the nail's layers and make it peel.
  • From now on, don't touch your nails with your fingers: the oil from your skin is enough to ruin adhesion.
Contents
  1. What you need
  2. Trim to the right length
  3. File and shape
  4. Push back the cuticles
  5. Buff the surface
  6. Dust and dehydrate
  7. The most common mistakes
  8. What's next?

It's often overlooked, but how long a gel lasts is decided before the first coat. Gel that lifts after a few days almost always comes from rushed prep: a bit of oil, a cuticle left on the nail, a surface that's too smooth. Allow 10 to 15 minutes for both hands: it's the best-invested time of the whole manicure.

What you need

  • nail clippers or nail scissors;
  • a gentle file (180/240 grit) for natural nails;
  • an orange-wood stick or a metal cuticle pusher;
  • a buffer (soft sanding block);
  • a dehydrator (“cleanser”, or isopropyl alcohol) and lint-free pads.

1Trim to the right length

Start by trimming the nail slightly longer than you want: the file will do the finishing. Cut in several small snips rather than one, especially on a dry nail that could split.

2File and shape

Always file in one direction, from the edge towards the center, never back and forth: sawing motions break up the nail's layers and make it peel. Keep the file perpendicular to the free edge for a square shape, or tilt it slightly to round it off.

To choose a shape, see the guide Nail shapes.

3Push back the cuticles

The cuticle is the thin, clear skin that sticks to the base of the nail. If gel is applied over it, it will lift from there. Soften it for a few minutes (warm water or oil), then gently push it back with the stick. On the nail plate, carefully scrape off any bits of skin still stuck to it.

4Buff the surface

Gently pass the buffer over the whole nail until it's matte with no shine left. The goal isn't to thin the nail but to create a micro-roughness the base can grip. Pay extra attention to the edges and near the cuticles, where gel lifts first.

5Dust and dehydrate

Brush off the dust, then wipe each nail with a pad soaked in dehydrator. From now on, don't touch your nails with your fingers: the oil from your skin is enough to ruin adhesion.

The most common mistakes

Mistake Result The fix
Filing back and forth Peeling nails, chipping gel File in one direction
Cuticle left on the nail Lifting at the base Push back and clean the plate
Surface still shiny Gel slides and lifts Buff the whole nail
Touching the nail after dehydrating Lifting in patches Dehydrate last, then hands off

What's next?

Once your nails are ready, move on to the base coat, the first layer of gel. The guide Applying UV gel step by step covers everything that follows.

In the 3D studio, the “Prepared natural nail” step is this clean, matte nail before any coat:

See the prepped nail in 3D

How to prep your nails before a UV gel manicure

Try it in the 3D studio

← All guides